Bosch DIVAR IP 2000, 2 Festplatten Manual de instalación

DIVAR IP 2000DIP-2040-00N, DIP-2042-2HD, DIP-2042-4HD en Installation Manual

LED indicator LED color LED state DescriptionSystem LED N/A Off Power offBlue On (default) System has booted in normal operation.Blue Blinking System

Chassis setup and maintenanceThis chapter covers the steps required to install components and perform maintenance on thechassis.!Caution!Review the wa

System setup - first stepsThe following installation directive provides information on Installation and Configuration.DIVAR IP systems are based on Wi

8. After entering the password, a message is displayed that you must change the passwordbefore logging on the first time. To confirm, click OK.9. Chan

Welcome page4 Click Next > to start the configuration.Notice!If VRM is not available on the computer or the license check fails, a corresponding er

Passwords pageThis page allows you to specify a password to protect the devices from unauthorized access.4 Enter the respective password, confirm the

Recorder pageThis page displays recorder information.4 Click Next > to continue. 16en | System setup - first steps DIVAR IP 20002013.09 | V2 | DOC

Device Selection pageThis page displays all network devices that are added to the system. Clicking Update startsthe scan process again.4 Click Next &g

Network pageThis page allows you to configure the network settings of connected devices.4 Click Next > to continue. 18en | System setup - first ste

Date and Time pageThis page allows you to synchronize the device time with the computer time or a SNTP timeserver.4 Click Next > to continue. DIVAR

Video Quality pageThis page allows you to define the image quality for live-viewing and to set the maximumbandwidth.4 Click Next > to continue. 20e

Recording pageThis page allows you to define the recording profiles.4 Click Next > to continue. DIVAR IP 2000System setup - first steps | en 21Bosc

Summary pageThis page displays a summary of all wizard settings.4 Click Apply to activate the configuration. 22en | System setup - first steps DIVAR I

Recovering the unitFollowing procedure describes how to restore the factory default image.To restore the unit to factory default image1. Start the uni

Additional documentation and client softwareDocumentation for Bosch Security System products can be found as follows:4 www.boschsecurity.com > sele

Bosch Sicherheitssysteme GmbHRobert-Bosch-Ring 585630 GrasbrunnGermanywww.boschsecurity.com© Bosch Sicherheitssysteme GmbH, 2013

Table of contents1Safety precautions 41.1 General safety precautions 41.2 Electrical safety precautions 51.3 ESD precautions 61.4 Operating precaution

Safety precautionsObserve the safety precautions in this chapter. General safety precautionsFollow these rules to ensure general safety:– Keep the are

!Warning!Handling of lead solder materials used in this product may expose you to lead, a chemicalknown to the State of California to cause birth defe

– Mainboard replaceable soldered-in fuses: Self-resetting PTC (Positive TemperatureCoefficient) fuses on the mainboard must be replaced by trained ser

System overviewThe DIVAR IP 2000 system is an affordable, easy to use all-in-one recording and managementsolution for network surveillance systems of

Device viewsThere are several LEDs on the front and rear of the chassis. The LEDs show the over-all statusof the system and the activity and health of

Rear view:2 3 45161 1x eSATA for data exportNote: Do not connect hard disk drivesfor recording.4 2x USB 3.0Note: Do not use these ports forkeyboard an