
AMC-4W Access Modular Controller | 3
Contacts
Inputs
The eight analog inputs can be used as digital or analog
contacts. For analog use, resistor values can be assigned
that permit additional testing for a cable break or short
circuit.
Relay outputs
The 8 relay outputs can operate in the following modes by
means of the jumper position:
•
Output is potential-free and is supplied with external
power
•
Power is looped in for the potential-free contact
outside (with additional individual protection)
General notes
•
Installation should be performed in the "secured
area".
•
You will find detailed connection conditions in the
installation manual.
•
The mains supply (230 V~) must be connected
on the customer's premises by an authorized
installer.
Technical Specifications
Hardware CPU RENESAS M16C80
256 kB-EPROM/FLASH
256 kB-SRAM
Serial EEPROM
RTC
Plug-in Compact Flash memory 64MB
Expansions: 128 MB, 256 MB or 1 GB
Battery for SRAM and RTC
Host address can be set using slide switch
Host interface:
- RS485 (2 or 4-wire)
- RS232
- Ethernet 10BaseT (TCP/IP) with RJ45 optional
4 Wiegand slave interfaces
8 relay outputs
8 analog inputs
Tamper switch
Ethernet 10BaseT (TCP/IP) with RJ45
2 (4) opto-decoupled interface RS485
LBus; RS485 interface, opto-decoupled,
2-wire, 19,200 Bd
Reset push-button
Temperature 0°C to +45°C
Supply 12V DC, max. 60VA
Available for external units: 56 VA
Protection type IP 20
Housing Base: PPO (UL 94 V-0)
Cover: Polycarbonate (UL 94 V-0)
Color White
Dimensions W x H x D (mm): 225 x 88 x 60
Weight Approx. 0.4 kg
Construction
type
Rail mounting
Ordering Information
AMC-4W-NET access controller
with Wiegand slave interfaces and network
connection to the host system Access En-
gine.
AMC 4-W-NET
AMC-4W-NET-CF access controller
Wiegand slave interfaces, network connec-
tion to the host system and Compact Flash
memory.
AMC 4-W-NET-CF
Accessories
AMC-MUX interface converter AMC MUX
AMC-MUX-EXT interface extension AMC MUX-EXT
www.boschsecurity.com
Comentarios a estos manuales