Bosch PIF645DE4E Manual de instrucciones descargar pdf (Pagina 40)

en Trouble shooting

Notes

■ If “ appears on the display, press and hold the

button for the relevant cooking zone in order to read

the fault code.

■ If the fault code is not listed in the table, disconnect

the hob from the mains power supply and wait

30 seconds before reconnecting it. If this code is

displayed again, contact the technical after-sales

service and specify which fault code has appeared.

■ If a fault occurs, the appliance will not switch to

standby mode.

The temperature sensor indica-

tor is not lighting up

The temperature sensor is not responding and

the indicator is not lighting up.

Replace the 3 V CR2032 battery. See the section entitled

~ "Changing the battery"

If this does not solve the problem, press and hold the symbol on

the temperature sensor for 8-10 seconds and then reconnect the

temperature sensor to the hob. See the section entitled

~ "Connecting the wireless temperature sensor to the control

panel"

If the problem persists, contact the technical after-sales service.

The indicator on the sensor

flashes twice

The battery in the temperature sensor has

almost run out. You may be interrupted the next

time you cook by the battery running out.

Replace the 3 V CR2032 battery. See the section entitled

~ "Changing the battery"

The indicator on the sensor

flashes three times

The wireless connection to the temperature sen-

sor has been broken.

Press and hold the symbol on the temperature sensor for 8-10

seconds and then reconnect the temperature sensor to the hob.

See the section entitled ~ "Connecting the wireless

temperature sensor to the control panel"

“Š‹‹‹

“Š‹‚‹

The operating voltage is incorrect/outside of the

normal operating range.

Contact your electricity supplier.

—…‹‹

The hob is not connected properly Disconnect the hob from the power supply. Check that it has

been connected as shown in the circuit diagram.

š“

Demo mode is activated Disconnect the hob from the power supply. Wait for 30 seconds

before reconnecting it. Touch any touch control in the next

3 minutes. Demo mode has now been deactivated.

Indicator/symbol Possible cause Remedial action

Do not place hot cookware on the control panel.

1 2 ... 35 36 37 38 39 40 41 42 43 44

Comentarios a estos manuales

Sin comentarios

Bosch PIF645DE4E Manual de instrucciones Pagina 40

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Bosch PIF645DE4E