Bosch PIC6..E1.. Guía de instalación descargar pdf (Pagina 20)

4 / CARING FOR AND CLEANING YOUR APPLIANCEEN

• CHANGING AND CLEANING THE ANTI-GREASE FILTERS

• CHANGING THE LIGHT BULB

• INSTALL THE T-SHARP OUTELT

— Removing the  lters as the instruction in Pic. 12

— You can clean the  lter as below measure:

1. Soak them for about 3 minute in hot water

(40-50 degrees) with a grease-loosening

detergent then brush it gently with a soft brush.

Please do not apply too much pressure, avoid

damaging it.

2. It can be put into a dishwasher with

detergent, set the temperature at around 60

degrees.

— Please do not use abrasive detergent for it will

damage the hood;

— Make sure that the hood is shut off before

cleaning;

— Installing the carbon  lter:

1. Remove the Al  lter, see Pic.12

2. Insert the carbon  lter in the rectangular

hole,  tting it over the motor.

3. After inserting the front edge of the carbon

 lter into the slot on the cooker hood. Lower

the back edge of the carbon  lter, until it

clicks into place at the rear of the rectangular

hole. Raise the two  xing bars, until they are

horizontal over the carbon  lter. See Pic 13

4. Place the Al.  lter back to position.

5. Apply reverse procedure to uninstall the

carbon  lter.

Take the bracket and glass off and then take

the broken light bulb off, See Pic 14.

Fix the new light bulb,glass and bracket on.

— Fix the outlet outlet on the T-sharp, see

Pic 15.

— Fix the T-sharp outlet on the inside

chimney, see Pic 16.

Warning

the charcoal cannot be washed or re-

cycled. It should be changed at least every

four months.

Attention

Before changing the lights, ensure

that the appliance is not live.

Pic 14

Pic 16Pic 15

Pic 12

Pic 13

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 143 144

Comentarios a estos manuales

Sin comentarios

Bosch PIC6..E1.. Guía de instalación Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Bosch PIC6..E1..