Bosch REG Sentry Access Control Manual de instrucciones descargar pdf (Pagina 15)

INST-164 Revision 4

Page 15 of 18

LED Location and Function

Figure 19: LED Location

DSP 1, Lit when a video input is detected. The LED is orange in colour. If this LED is not lit then you

should inspect your video cable and ensure that your camera is functioning correctly.

DSP 2, Lit when a live video stream is being provided to the sentry viewer, the LED is blue in colour.

During normal operation the live stream should be switched off, you should always ensure that DSP2 is

unlit after you have commissioned the unit.

DSP 3, Lit when a recognised number plate is present on the black/white list, the LED is orange in

colour.

DSP 4, Lit when a number plate has been processed, the LED is green in colour.

D1, unused

D2, unused

D3, Lit when the relay has been switched. The LED is orange in colour. When this LED is lit the relay is

energised and your barrier should operate, if this is not the case inspect all connections from the unit to

the barrier control box.

D4, unused

DSP_F, Indicates either a communications fault or a processing fault, this LED will flash continuously

when there is no network connection (however the unit should function normally i.e. licence plates are

processed). If the Reg-Sentry is not functioning normally (i.e. no licence plates are processed) and this

LED is flashing continuously then there is a fault with the unit and you should return the unit for repair.

This LED is green in colour.

POWER, this LED will flash briefly if there is a power fault. The LED colour is RED. During normal

operation this LED will be unlit. If this LED is lit, inspect all power connections.

1 2 ... 10 11 12 13 14 15 16 17 18

Sin comentarios

Bosch REG Sentry Access Control Manual de instrucciones Pagina 15