Bosch WTW87560GB Instrucciones de operaciones descargar pdf (Pagina 24)

en Faults and what to do about them

Note: If you cannot rectify the fault yourself by turning the dryer off and on, please

contact our after-sales service.

Drying time too long? ■ The fluff filter may be dirty and cause drying to take longer. Clean the fluff

filter.

■ If the air inlet on the dryer is blocked or not freely accessible, this may

increase the drying time. Make sure that the air inlet remains unobstructed.

■ If the ambient temperature is higher than 35 °C, this may extend the drying

time.

■ Insufficient air circulation in the room may increase the drying time. Venti-

late the room.

Display panel goes off

and Start button flashes.

Not a fault. Energy saving mode is active ~ Page 7.

Residual water in the

condensate container

despite the dryer being

connected to the con-

densation drain*.

Not a fault. If the condensation drain is installed, residual water remains in the

condensate container due to the dryer's self-cleaning function.

Humidity in the room

increases.

Not a fault. Make sure the room is sufficiently ventilated.

Power cut. The drying programme is interrupted. Remove the laundry and spread it out, or

restart the programme.

Unusual noises when

drying.

Not a fault. Noises are produced by the automatic cleaning of the heat

exchanger ~ Page 20.

The dryer feels cold

despite drying.

Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.

Faults Cause/remedy

* depending on the model

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Bosch WTW87560GB Instrucciones de operaciones Pagina 24