Bosch WTW87560GB Instrucciones de operaciones descargar pdf (Pagina 23)

Faults and what to do about them en

3 Faults and what to do about them

Faults and what to do about them

Faults Cause/remedy

ð on the display panel

and drying has been

interrupted.

■ Empty the condensate container and press the Start button ~ Page 18.

■ If the optional condensation drain* is installed, the drain hose may be

blocked or kinked. Check the hose for deposits and flush the hose out. Lay

the hose without any kinks.

é on the display panel. Clean the fluff filter and press the Start button ~ Page 17.

SelfCleaning on the ’

display panel.

Not a fault. The heat exchanger is cleaned automatically. Do not pull out the

condensate container while this is displayed.

Dryer does not start. ■ Mains plug plugged in or fuse checked?

■ Programme selected? Select a programme.

■ Dryer door open? Close the door.

■ Childproof lock activated? Deactivate the childproof lock.

■ "Ready in" time selected? Programme starts after a delay ~ Page 15.

Creasing. ■ Creasing occurs when you have exceeded the maximum load or selected

the wrong programme for the type of fabric. All the required information

can be found in the programme table ~ Page 13.

■ Remove clothes immediately after drying; creasing may occur if they are

left in the drum.

Water is leaking out. Not a fault; the dryer may be positioned on an incline. Level the dryer.

Laundry is not dried cor-

rectly or is still too damp.

■ After the end of the programme, warm laundry feels damper than it actually

is. Spread the laundry out and allow the heat to disperse.

■ Finely adjust the dryness level – this extends the drying time but does not

increase the temperature. Your laundry will become drier ~ Page 15.

■ Select a programme with a longer drying time or increase the drying level.

This does not increase the temperature.

■ Select a timed programme for subsequent drying of laundry that is still

damp ~ Page 13.

■ If you have exceeded the maximum load for the programme, the laundry

may not be dried properly.

■ Clean the moisture sensor in the drum. A fine layer of limescale may

adversely affect the performance of the sensors and your washing will not

dry properly ~ Page 22.

■ Drying has been interrupted as a result of a power cut, because the conden-

sate container is full or because the maximum drying time has been

exceeded.

Note: See also the laundry tips ~ Page 12.

* depending on the model

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Comentarios a estos manuales

Sin comentarios

Bosch WTW87560GB Instrucciones de operaciones Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Secadoras Bosch WTW87560GB