Bosch DVR-16K Guía de instalación descargar pdf (Pagina 10)

10 en | Subsystem Cable Connections RAID Subsystem DVA-08K and DVA-16K | Quick Installation Guide

F.01U.027.800 | V1 | 2006.05 Bosch Security Systems

7 Subsystem Cable Connections

7.1 Power Cables

1. Connect the two (2) provided power cables to the power sockets on the back of the sys-

tem (see Figure 7.1).

Fig. 7.1 Power Supply Module

2. Make sure the power source is within the correct power range (100 to 240 VAC) prior to

powering on. Auto-ranging is supported by the power supply modules.

3. Plug the other end of power cords into the power source.

7.2 Host Channels

1. The subsystem comes with two (2) dual-stack VHDCI host connectors on the controller

module’s faceplate. One (the “In” port) can be connected to an external host computer

or DVR. Another (the “Out” port) can be used for Daisy Chain to connect another sub-

system. (See Figure 7.2)

Make sure to use the correct cable for your host computer or DVR (see

Section 12 Connecting a Digital Video Recorder).

Fig. 7.2 Controller Module

2. Attach the VHDCI SCSI connector to the subsystem and attach the other end to the host

computer or DVR. Note that the subsystem comes with a firmware terminator and

requires no additional terminators on the subsystem side.

3. If two subsystems are cascaded, disable the firmware terminator setting on the sub-

system which is connected in between the host and another subsystem (see

Section 12 Connecting a Digital Video Recorder).

DVA-08K DVA-16K

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sin comentarios

Bosch DVR-16K Guía de instalación Pagina 10