Bosch VIP X1600 Module Manual de usuario descargar pdf (Pagina 15)

VIP X1600 XFM4 Installation | en 15

Bosch Security Systems Installation and Operating Manual DOC | V4.2 | 2010.07

Removing and Exchanging Modules

It is also possible to install, remove and exchange modules during operation.

1. Before removing a module, terminate all recordings currently running in this module.

2. When installing a module, please ensure that the cover is kept for future use.

3. When removing a module, it is essential that the corresponding slot be closed with the

cover if a module is no longer to be used in this slot. The opening must be closed to

ensure that the unit remains cool.

4.3 Connections

Cameras

You can connect a maximum of four video sources to the module. Any cameras and other

video sources that produce a standard PAL or NTSC signal are suitable.

1. Connect each of the cameras or other video sources to BNC sockets Video In 1 to

Video In 4 using a video cable (75 Ohm, BNC connector).

2. If the video signal is not looped through, termination is performed by a software setting if

necessary (see Section 5.16 Advanced Mode: Video Input, page 37).

Audio Connections

The VIP X1600 XFM4 module has two audio ports for audio line signals.

The audio signals are transmitted two-way and in sync with the video signals. As a result, you

can connect a speaker or door intercom system at the destination point, for example. The

following specifications should be complied with in all cases.

The stereo plugs must be connected as follows:

1. Connect two audio sources with line level to the Audio In socket of the module with a

3.5 mm / 1/8 in. stereo plug.

2. Connect a unit with line-in connection to the Audio Out socket of the module with a

3.5 mm / 1/8 in. stereo plug.

CAUTION!

Ensure that Slot 1 is always populated by a module, even when modifying the installation.

Malfunctions may occur when the VIP X1600 XF base system is switched on without a

functional module in Slot 1.

2 × Line In: Impedance 9 kOhm typ., 5.5 V

p-p

max. input voltage

1 × Line Out: Impedance 10 kOhm typ., 3.0 V

p-p

max. output voltage,

impedance 16 Ohm min., 1.7 V

p-p

max. output voltage

Contact Audio In Audio Out

Tip Channel 1 Channel 1

Middle ring Channel 2 –

Lower ring Ground Ground

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 121 122

Comentarios a estos manuales

Sin comentarios

Bosch VIP X1600 Module Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Bosch VIP X1600 Module