
8 en | Safety Information VIP X1600 XFM4
DOC | V4.2 | 2010.07 Installation and Operating Manual Bosch Security Systems
2 Safety Information
2.1 Electric Shock Hazard
– Always install a module in the appropriate VIP-X1600-XFB base system or VIP-X1600-B
base system housing only.
– If a fault occurs, disconnect the VIP X1600 XF from the power supply and from all other
units.
– Install the power supply and the unit only in a dry, weather-protected location.
– If safe operation of the unit cannot be ensured, remove it from service and secure it to
prevent unauthorized operation. In such cases, have the unit checked by Bosch Security
Systems.
Safe operation is no longer possible in the following cases:
– if there is visible damage to the unit or power cables,
– if the unit no longer operates correctly,
– if the unit has been exposed to rain or moisture,
– if foreign bodies have penetrated the unit,
– after long storage under adverse conditions, or
– after exposure to extreme stress in transit.
2.2 Installation and Operation
– The relevant electrical engineering regulations and guidelines must be complied with at
all times during installation.
– Relevant knowledge of network technology is required to install the unit.
– Before installing or operating the module, please ensure you have read and understood
the documentation for the VIP X1600 XF base system and for any other equipment
connected to the module, such as monitors. The documentation contains important
safety instructions and information about permitted uses.
– Perform only the installation and operation steps described in this manual. Any other
actions may lead to personal injury, damage to property or damage to the equipment.
2.3 Maintenance and Repair
– Never open the housing of a VIP X1600 XF base system. The unit does not contain any
user-serviceable parts. Remove only the supplied cover when installing a module.
– Do not change any components in a VIP X1600 XF base system or a module. The units do
not contain any user-serviceable parts.
– Never open the housing of the power supply unit. The power supply unit does not contain
any user-serviceable parts.
– Ensure that all maintenance or repair work is carried out only by qualified personnel
(electrical engineers or network technology specialists).
Comentarios a estos manuales