Bosch NET 682 C Manual de instrucciones descargar pdf (Pagina 21)

INSTALLATION

INSTALLATION INSTRUCTIONS

19

STANDARD PLUME

MANAGEMENT INSTALLATION

STANDARD PLUME MANAGEMENT INSTALLATION

8 718 682 335b (09.2008)

NOTE: to ease assembly of the flue components,

grease seals lightly with the solvent-free grease

supplied.

Check all the seals are seated properly in the

grooves provided and are in good condition.

All flue joints must be sealed to prevent leakage

of condensate and flue products.

Fitting the standard plume management

system:

1

Remove screws (C) and discard the

complete terminal end (D).

2

Fit the terminal bend (E) to the terminal

outlet and refix screws (C) to secure.

Rotate terminal bend (E) for angled fluing.

DO NOT rotate the complete flue terminal

assembly.

NOTE: the flue terminal outlet has built-in

stops to limit rotation for horizontal fluing

to allow condensate to run back into the

boiler for safe disposal. Do not attempt to

force beyond the limit stops.

All plume management sections must

rise by at least 173mm per metre (10°)

from the terminal to ensure that

condensate flows back into the boiler.

3

Mark, drill (protecting bend (E) from

debris) and fit clamp wall plug (G).

4

Screw clamp (F) into wall plug (G) to the

required distance as shown.

5

Push-fit the extension tube (H) as far as

possible into bend (E), then withdraw

10mm to allow for expansion.

6

Secure extension (H) to wall with clamp

(M) in position shown, using screws (J).

7

Push-fit outlet assembly (L) as far as

possible into the extension tube (H).

Rotate the outlet assembly (L) to the

direction required and secure to the

extension (H) with self-tapping screw (K)

supplied.

1

E

C

C

D

2

4

3

F

H

E

M

J

L

K

G

5

6

7

M

6

CONNECTORS

CLAMPS

±80°

65mm

4

F

10mm

1 2 ... 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios