
5
■ Use a small saucepan for small quantities. A larger, less full
saucepan requires a lot of energy.
■ Cook with only a little water. This will save energy. Vitamins
and minerals in vegetables are preserved.
■ Always cover as large an area of the hotplate as possible
with your saucepan.
■ Switch to a lower heat setting in good time.
■ Select a suitable ongoing cooking setting. You will waste
energy by using an ongoing cooking setting which is too
high.
■ Use the residual heat of the hob. For longer cooking times,
you can switch the hotplate off 5-10 minutes before the end
of the cooking time.
Getting to know your appliance
The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.
The control panel
Notes
■ When you touch a symbol, the respective function is
activated.
■ Always keep the controls dry. Moisture reduces their
effectiveness.
■ Do not pull pans close to the displays and sensors. The
electronics could overheat.
The hotplates
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
If
• appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
œ. The display remains lit until the hotplate has
cooled sufficiently.
Displays
‚-Š
Heat settings
•/œ
Residual heat
‘
Electronic boil start control
‰‰
Timer
Controls
#
Main switch
w
Electronic boil start control
$
Hotplate selection
- D
Control panel pause / Childproof lock
1û2û3û4û
Settings range
ö
Automatic zone control
0
Timer
Controls
Hotplate Activating and deactivating
$
Single-circuit hotplate
ð
Dual-circuit hotplate
Select the hotplate and touch the
ö symbol
ò
Tri-circuit hotplate
Select the hotplate, touch the
ö symbol, and the 2nd filament circuit is activated
Touch the
ö symbol again and the 3rd filament circuit is activated
î
Extended cooking zone
Select the hotplate and touch the
ö symbol
Activating the hotplate: The corresponding indicator lights up.
Switching on the hotplate: The size of hotplate which was last set is automatically selected
Comentarios a estos manuales