Bosch AutoDome 100 Series Manual de usuario descargar pdf (Pagina 16)

16 en | Troubleshooting Guide AutoDome 100 Series Fixed Camera

F.01U.216.346 | 1.0 | 2011.04 User Manual Bosch Security Systems, Inc.

Inside of

EnviroDome bubble

is foggy

– Check the status of the Heater Module (ON-66-ENTER).

If status reports Heater No Power, then:

– Turn off the power to the AutoDome.

– Check the FX103 fuse in the Power Supply Box for power (24 V) to the heater module.

If O.K., then:

– Check all wiring and connector pins to the heater module.

Low Voltage flashing

on monitor display

– If using a non-Bosch power supply, confirm that it meets the Bosch AutoDome power

ratings. See the AutoDome Datasheet for specifications.

If O.K., then:

– Check the mains input line voltage.

If O.K., then:

– Check that the maximum wire length from the power supply has not been exceeded.

See the VG5 AutoDome Installation Manual.

If O.K., then:

– Measure the AC voltage input to the camera while power is applied to the camera. The

voltage must be ≥ 21 VAC to stop the message.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Bosch AutoDome 100 Series Manual de usuario Pagina 16