Bosch NTC-255-PI Manual de usuario descargar pdf (Pagina 77)

IP Camera 200 Series Advanced Mode | en 77

Bosch Security Systems Installation and Operation Manual AR18-10-B012 | v1.5 | 2011.01

6.7 Interfaces

6.7.1 Alarm input

Configure the alarm trigger for the camera.

Select N.C. (Normally Closed) if the alarm is to be triggered by

opening the contact.

Select N.O. (Normally Open) if the alarm is to be triggered by

closing the contact.

Name

Enter a name for the alarm input. This name can be displayed

below the icon for the alarm input on the LIVEPAGE. (Do not

use any special characters, for example &.)

6.7.2 Relay

Configure the switching behavior of the relay output.

Select different events that automatically activate an output.

For example, turn on a floodlight by triggering a motion alarm

and then turn the light off again when the alarm has stopped.

Idle state

Select Open for the relay to operate as an N.O. contact, or

select Closed if the relay is to operate as an N.C. contact.

Operating mode

Select an operating mode for the relay.

For example, if you want an alarm-activated lamp to stay on

after the alarm ends, select Bistable. If you wish an alarm-

activated siren to sound for ten seconds, for example, select

10 s.

Interfaces

> Alarm input

>Relay

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 103 104

Sin comentarios

Bosch NTC-255-PI Manual de usuario Pagina 77