
F00E900050 KTS 570 / ESI[tronic] INSTALLATION GUIDE
FIRMWARE UPDATE
If your KTS 570 was not connected to the PC during software and firmware
installation you will need to do a Firmware Update as described below.
1. Connect the KTS 570 with the PC via USB and supply external power to the
KTS. Verify power with blinking green light on end of unit. Firmware Update will
not work wirelessly – unit must be connected via USB.
2. Open the Bosch Diagnostic Device Configuration (DDC) from the Control
Panel
3. Double Click the DDC icon.
4. Select the "Firmware Update" tab. Click Refresh
Comentarios a estos manuales