Bosch DS7200V2-EXP Guía de usuario descargar pdf (Pagina 48)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 48

Bosch Security Systems | 8/04 | 4998153891C

4.3 Area Wide Parameters

The parameters in this section configure the control panel’s areas. Each area has 16 characters of programmable

text for an area name and 16 characters of programmable area idle text, which appear on the LCD Keypad

display.

The DS7240V2 supports up to four areas. The DS7220V2 supports up to two areas.

All control panel text is programmed from the text keypad in a special text-programming mode. See Text Entry

Addresses on page 7 for text programming instructions.

Area # Account Number

• Address/Default: See Table 8

• Selections: 0 to 15 (see Table 9)

Table 8: Account Number Addresses/Defaults

Area Account # for Routing

Destination 1

Account # for Routing

Destination 2

Default Account #

(for both destinations)

1 Address 0276 to 0281 Address 0286 to 0291 10, 10, 10, 10, 0, 0

2 Address 0298 to 0303 Address 0308 to 0313 10, 10, 10, 10, 0, 0

3 (DS7240V2 only) Address 0320 to 0325 Address 0330 to 0335 10, 10, 10, 10, 0, 0

4 (DS7240V2 only) Address 0342 to 0347 Address 0352 to 0357 10, 10, 10, 10, 0, 0

Table 9: Account Number Entry Selections

For this Selection Press this Key For this Selection Press this Key

0 10 8 8

1 1 9 9

2 2 B 11

3 3 C 12

4 4 D 13

5 5 E 14

6 6 F 15

7 7 Terminate 0

Each area uses the account number entered here to report to the ARC receiver. Different account numbers can be

programmed for two routing destinations. See Routing Destinations on page 9 for a complete description of how the

control panel directs reports to the routing destinations.

Account numbers can contain up to six (6) digits. If less than four digits are entered, the control panel adds zeros

to the end to make a four-digit account number.

The control panel automatically truncates the account number to the maximum length supported by that format.

See Control Panel Events and Reporting Formats on page 138 for a complete description of the reporting formats

available to the control panel.

One account number digit occupies each address. Use a zero (0) to terminate the account number entry if it is less

than six digits in length.

For example, to set an account number of 1234, enter 1 2 3 4 0 (0 = Terminate).

Use “10” ([1][0] from the keypad) to enter “0.” Use “0” to terminate the account number.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 155 156

Comentarios a estos manuales

Sin comentarios

Bosch DS7200V2-EXP Guía de usuario Pagina 48

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch DS7200V2-EXP