Bosch B450 Especificaciones descargar pdf (Pagina 5)

Introduction

About documentation

This document is the intellectual property of Bosch Security Systems, Inc. and is protected by

Trademarks

All hardware and software product names used in this document are likely to be registered

trademarks and must be treated accordingly.

Bosch Security Systems, Inc. product manufacturing dates

Use the serial number located on the product label and refer to the Bosch Security Systems,

Inc. website at http://www.boschsecurity.com/datecodes/.

The following image shows an example of a product label and highlights where to find the

manufacturing date within the serial number.

Installation workflow

To install and configure the device, use the workflow below and follow in sequential order

from top to bottom, marking off each box as you complete a step.

Caution!

Always power down the control panel when connecting the B450. Power down the control

panel by unplugging the transformer and disconnecting the battery.

Plan the installation of the B450 Conettix Plug-in Communicator Interface

Unpack the device contents

Power down the system

Select the bus address value for the compatible control panel (This will automatically

configure the module to work with a compatible control panel. Refer to Setting the bus

address, page 10)

Insert the desired plug-in communicator into the B450 (Refer to Insert the B44x

communication module (required and available separately), page 10)

Mount the B450 into the enclosure (Refer to Mount the module in the enclosure, page 11)

Wire the B450 to a compatible control panel (Refer to Wire to the control panel, page 13)

Power up the system

2.1

2.2

2.3

Conettix Plug-in Communicator

Interface

Introduction | en 5

Bosch Security Systems, Inc. Installation and Operation Guide 2013.09 | 02 | F.01U.282.875

1 2 3 4 5 6 7 8 9 10 ... 47 48

Sin comentarios

Bosch B450 Especificaciones Pagina 5