Bosch D9000, G Manual de usuario descargar pdf (Pagina 3)

3 of 6

IAGRAM 1: SECURITY PANEL TO DX4010I SERIAL INTERFACE MODULE WIRING DIAGRAM

The following diagram shows how to wire the DX4010I to the panel.

PANEL PROGRAMMING

The following steps outline settings required and concepts to keep in mind when programming a Bosch

security system.

IP SWITCHES

The DX4010I serial interface module has a block of 8 dip switches. The suggested default settings for

the switches correspond to address 80, which is as follows:

 Switches 1-4 On

 Switches 5-8 Off

For more information on the switch settings, consult the DX4010I documentation.

ANEL SETTINGS

All of the following settings in RPS software must be set correctly:

GV2AUX/RADXAUX:

• SDI Automation must be set to ‘Enabled - Yes’

• Baud Rate 9600 with NO Parity and 1 Stop Bit

• Address 80 Supervision must be set to ‘No’

• RTS and DTR ‘FORCE OFF’ (This will disable Flow Control)

• Status Rate 0

Command Center:

• CC Address of each Area/Partition you wish to arm/disarm from g! must have Keypad

Supervision set to ‘No’

• One ‘Area Wide’ Keypad for each Area (See Keypad Setup and Partitions below)

User Interface:

• PIN Code Settings (See Arming PIN Codes and Auto-Arm below) must match Configurator

• Auth levels must be correct for PIN Codes to work at Keypad or from g!

• Move to Area Command 50 must be ‘Enabled’ (GV2 Panels)

1 2 3 4 5 6

Sin comentarios

Bosch D9000, G Manual de usuario Pagina 3