
– 18 –
Optional Operations (continued)
Day to Day Operations (continued)
Zone Bypass
There may be occasions when it is desirable or necessary to temporarily bypass one or more zones prior to arming the system. Bypass
commands only work when the control panel is disarmed. For instance, an open window may cause the DS7447/DS7447E display to read
“Not Ready” followed by the zone number. The DS7445/DS7445i may have one of its zone 1-8 LEDs on steady. If bypassing is performed
from a Master keypad, you must be in Single Partition Mode. Bypassing without arming is not allowed from an RF (wireless) keypad. If more
than one zone requires bypassing, simply enter the additional zone numbers.
Note: See Force Arming for another method of zone bypassing.
The zone number must be entered as a three digit number. Example: 001, 062, 125, etc.
Note: All bypasses are cleared when the system is disarmed, unless they are 24-hour zones or
Day-Monitor zones. To clear a bypass on a 24-hour zone or Day-Monitor, use one of the two methods above.
Bypassing
Desired
Sequence
Happen
To Do
Bypass Faulted
Zones
[PIN] + [Bypass]
[XXX] [XXX] [XXX] ‡
The green Status LED will flash if no other zones are faulted.
Read Bypassed
Zones
PIN] + [Bypass]
•
“Bypass” will be displayed on a DS7447 keypad followed by
the zone number(s) of any bypassed zones.
•
The zone LED of any zone being bypassed will flash on a
DS7445/DS7445i keypad.
Clear Individual
Bypassed Zone(s)
[PIN] + [Bypass]
[XXX] ‡
The specified Individual zone bypass will clear.
Clear All Bypasses [PIN] + [Bypass] [*] All bypasses will clear.
Arm control panel,
if desired, after
bypassing.
‡ [XXX] = a 3-digit zone number
Comentarios a estos manuales