Bosch DS7447 Guía de usuario descargar pdf (Pagina 36)

– 36 –

Note: Entering the command sequence [Master Code] [#] [0] [3] [#] will cause the DS7447/DS7447E keypad to read back the temporary code expiration

date.

Changing the Expiration Date for Temporary PINs

The Expiration Date for Temporary PINs can only be changed in Master Programming Mode, so they are not programmable from an RF

(wireless) keypad.

Note: You should write down your entries before you enter the Master Code Programming Mode and have them with you as you begin

programming. Make your entries promptly. If a long delay occurs in your entries, the 3-beep error tone occurs and exits you from the

programming mode.

It is recommended that this procedure be performed at a DS7447/DS7447E keypad. No visual clues will be given from a

DS7445/DS7445i keypad.

Personal Identification Numbers (continued)

Steps to Change the Expiration Date Command Sequence If Accepted, DS7447/DS7447E Display

Reads:

Enter Master Programming Mode. [Master PIN] + [#] [0] “3 Change Date of Code Expiration” *

(display will scroll to this)

Enter a 3 for Date of Code Expiration

Setup programming.

[3] “Enter Month”

(01 … 12)

Enter the Expiration Month. [0] [1] through [1] [2]

January December

“Enter Day”

(01 … 31)

Enter the Expiration Day. The

Temporary PIN will expire at Midnight

on the day selected.

[0] [1] through [3] [1] “Enter Year”

(XX) End with #

Enter the Year. Last two digits of the year followed by [#] “Month, Day, Year”

A long beep signifies acceptance.

* = This will display only when in Single Partition Mode.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Sin comentarios

Bosch DS7447 Guía de usuario Pagina 36