CCTV | Allegiant® Matrix Switcher Systems | Selection Guide | May 2009
www.boschsecurity.us 800.289.0096
For large size, modular based Allegiant systems.
• Modular construction using individual Video Input
Modules and Video Output Modules offers the
convenience of variable system sizes. A single bay LTC
8800 system offers increments of 32 camera inputs and 4
monitor outputs up to a maximum system capacity of 256
cameras by 32 monitors. By adding the LTC 8802 series
Monitor Expansion Bay, the system capacity can be
expanded to support a maximum of 64 monitors.
• Optional external alarm and remote control signal
distribution accessory devices available.
• Full control and programming by up to 32 keyboards.
• RS-232 Serial port for external PC interface.
• RS-232 Printer port for external logging printer.
• Integral 6-U high rack enclosure.
• 2-digit site and 4-digit camera identication mode.
Ordering Information:
Ordering main system components involves 3 to 5 part
numbers. First, select the appropriate main CPU bay model
based on AC line voltage requirements as listed below.
An external power supply will be required for each Alarm
Interface Unit when quantities are greater than one. The
TC120PS power supply is used for 120VAC line sources,
and the TC220PS is used for 230VAC line sources.
If the system will include controllable PTZ equipped
cameras, add one LTC 8568/00 Signal Distribution Unit for
up to 32 separate control code outputs or one LTC 8768/00
Signal Distribution Unit for up to 64 separate control code
outputs. If required, LTC 8569/x0 or LTC 8571/x0 series
Code Merger Units models are available which provide an
additional 32 or 64 outputs respectively when cascaded to
the Signal Distribution unit.
If the system will utilize 9 to 16 keyboards, one LTC 8714/
x0 Keyboard Port Expander will be required. For each
expanded keyboard, a LTC 8557/x0 Remote Hookup kit is
required.
Installation basics:
Install main bay in rack, insert the VIMs and VOMs into the
bay, then connect camera and monitor coax cables to BNC
connectors on rear of unit. Connect one or more keyboards
for programming and control. If applicable, connect
external PC, external Alarm Interface unit for alarms, and
external Signal Distribution unit for camera control
functions to appropriate data connections on rear of unit.
System programming can then be accomplished using
either a system keyboard or via one of the optional external
Bosch PC based software packages (see accessory
section).
LTC 8800 Series
Main CPU Bay AC Line Voltage
LTC 8801/60 120VAC, 60 Hz
LTC 8801/50 230VAC, 50Hz
(9 paginas)
(8 paginas)
(2 paginas)
(12 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales