Bosch LTC 9420 Series Instrucciones de operaciones descargar pdf (Pagina 8)

2.5 Tilt Stop Adjustment (All Models)

After the unit is installed and all wire connections are made,

apply proper power to the control unit. Refer to Figure 5:

Tilt Stops (Side View - Plug Removed) and adjust the

tilt stops as follows:

1. With the front of the pan/tilt facing you, remove the left

hub cap. The tilt stop adjustment screws are now

exposed.

2. Using the control unit, tilt the bracket up to the desired

position and stop the unit. Use the 3/32-inch Allen

wrench to loosen the Tilt Up stop. Slide the stop Up

until a faint click is heard (indicating switch actuation).

Tighten the Tilt Up limit stop screw.

3. Using the control unit, tilt the bracket to the desired

position and stop the unit. Use the 3/32-inch Allen

wrench to loosen the Tilt Down stop. Slide the stop

Down until a faint click is heard. Tighten the Tilt Down

limit stop screw.

4. Operate the control unit to verify proper tilt stop range

and operation. Repeat above sequence if necessary.

Make certain both tilt stop screws are snug. Replace the

hub cap.

Caution: Do not operate pan/tilt unit without

stops. Limit stops should not be adjusted

while unit is operating.

Tilt Up (CCW) StopTilt Down (CW) Stop

FRONTREAR

S928A21CE

Figure 5: Tilt Stops (Side View - Plug Removed)

2.6 Pre-Position Models

The 345° models with pre-position capability have “P” suffix

in the model number. These models require wiring

connections to pins 1 through 4, 8 and 9, and the use of a

controller or receiver/driver with the pre-position function.

Pan and tilt operation and limit stop adjustments, function

the same as the previous models described.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Bosch LTC 9420 Series Instrucciones de operaciones Pagina 8