Bosch Solution 144 Guía de usuario descargar pdf (Pagina 24)

Solution 144

24 Bosch Security Systems 04/12 BLCC600U

User Guide

2. Use the [] and [] keys to select the zone that

you want to walk test, then press [OK] to select.

Alternatively, you can enter the zone number, then

press [OK].

The keypad will display the zone to be tested.

To test zone Zn1

open then close

Zone 1 Name

Press OK or MENU

3. Open and close the zone that needs to be tested.

When the zone has been successfully faulted and

restored, the keypad will display:

Zn1 Zone 1 Name

Test Successful

Press OK or MENU

4. Press [OK] to save and exit, or press [MENU] to exit

without saving.

Outputs

The control panel can have up to a maximum of 37 outputs.

Five outputs are available as standard with an additional 32

available when the optional output expanders are tted.

Your installer will advise you on the exact makeup and

conguration of you system.

Outputs > Commands >

Output Status

MENU 4-0-0

This menu allows you to view the status of each output.

Enter programming mode (PIN + MENU) then,

1. Ensure that the system is turned o.

2. Press [MENU] + [4] + [0] + [0].

The keypad will display a list of outputs that the

status may be viewed.

3. Using the [] and [] keys, highlight the output

that you want to view the status information, then

press [OK] to select. Alternatively, you can enter the

output number and then press [OK].

The keypad will display the following when the

output is o and OK:

Output 1 Name Op1

Is OFF and Ready

Press OK or MENU

The keypad will display the following when the

output is o and missing:

Output 1 Name Op1

Is OFF and Ready

Connection Trouble

Press OK or MENU

The keypad will display the following when the

output is ON and OK:

Output 1 Name O1

Is ON and Ready

Press OK or MENU

The keypad will display the following when the

output is ON and missing:

Output 1 Name Op1

Is ON and Ready

Connection Trouble

Press OK or MENU

4. Press [OK] to save and exit, or press [MENU] to exit

without saving.

Outputs > Commands >

Turn Output On/O

MENU 4-0-1

This menu allows you to turn outputs that have been

programmed by your security company on or o. These

outputs can be programmed to control outside lighting,

pool pumps, watering systems etc.

Enter programming mode (PIN + MENU) then,

1. Press [MENU] + [4] + [0] + [1].

If a valid PIN is required, the keypad will prompt you

to enter your PIN.

2. Use the [] and [] keys to select the output name

that you want to change, then press [OK] to select.

Alternatively, you can enter the output number,

then press [OK].

3. To toggle the output on or o, use the [ON] and

[OFF] keys.

The keypad will display the following when the

output is o:

Output 1 Name Op1

Output is OFF,

To turn ON, Press ON.

To Go Back Press OK

To turn the output on, press [ON].

The keypad will display the following when the

output is on:

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Comentarios a estos manuales

Sin comentarios

Bosch Solution 144 Guía de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch Solution 144