Bosch PCI815B91A Instrucciones de operaciones descargar pdf (Pagina 9)

connected first and that all wires are connected to the

correct terminals. Fig. 4.

Gas

During the planning stage, consider the position of supply

connections.

The cooktop must be connected to

the gas supply with

upstream connection of an isolation valve in accordance

with the respectively valid regulations. We recommend

that the isolation valve be fitted prior to the cooktop to

enable isolation of cooktop from gas supply. The valve

must be easily accessible at all times.

To find out the factory set gas type, see bottom of

cookto

p next to gas connection.

Remove plastic cap from gas supply line prior to

installation

Fit regulator (N.G.) or a test point (Universal LPG) directly

the R 1/2’’ connection as per Fig. 5. and Fig. 6.

Direction of gas flow is indicated on the rear of the

regul

ator.

For position of the inlet connection refer Fig.1.

Use pipe compound or thread se

alant, properly theaded

pipes and careful assembly procedure so that there is no

cross threading, etc., which might cause damage or

leakage.

Make sure that all connections peformed are free of

akage.

The manufacturer does not accept any liability for

akage on connections performed by the installer or if

the L-tube is moved or twisted.

Fig. 5 Fig. 6

There are two ways to carry out the connection to the

main gas line:

A. The hotplate can be connected with rigid pipe as

specified in AS/NZS 5

601.1

B. Flexible Hose: If installing with a hose assembly, install

with a hose

assembly that complies with AS/NZS 1869

(AGA Approved), 10 mm ID, class Bor D, no more than

1,2 m long and in accordance with AS/NZS 5601.1.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Comentarios a estos manuales

Sin comentarios

Bosch PCI815B91A Instrucciones de operaciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Bosch PCI815B91A