
Praesideo PRS-CSM / PRS-CSRM / PRS-CSKPM en | 18
Bosch Security Systems B.V.
IUI PRS-CS(R)(KP)M | V1.0 | 2013.12
Installation and User Instructions
2.2.4 Headset/Volume control (4)
This 6-pin connector provides the connection to the
headset and the volume control. This volume control
also controls the volume of the loudspeaker connected
to connection 3.
A logarithmic potentionmeter R (typical value: 100
kohm) is used to attenuate the audio signal.
If a volume control is not needed, pin 3 and 4 must be
connected to each other. The volume level of the
earphone or loudspeaker is then at its maximum.
figure 2.6: Supervised control input
figure 2.7: Non-supervised control input
Warning
Do not connect DC or AC signals to the control
inputs, otherwise the input circuit may be
damaged. Only use voltage-free contacts.
Note
Do not combine control input wires of multiple
control inputs (e.g. do not use a common return
wire).
10k:
10k:
RTN Control input
RTN Control input
table 2.4: Headset/Volume Control connector details
Pin Signal
1 Headset (mic +)
2 GND (mic -)
3 Audio-in from volume control
4 Audio-out to volume control
5 GND (earphone -)
6 Earphone +
figure 2.8: Headset connection diagram
Microphone
R
Earphone
Volume
Headset
1
2
3
4
5
6
Comentarios a estos manuales