Bosch CS 150 RC Manual de instrucciones descargar pdf (Pagina 7)

Praesideo PRS-CSM / PRS-CSRM / PRS-CSKPM en | 7

Bosch Security Systems B.V.

IUI PRS-CS(R)(KP)M | V1.0 | 2013.12

Installation and User Instructions

1.2.1 Back-up supply/Buzzer (1)

This 4-pin connector provides the input for a backup

power supply and a buzzer. Typically a 24V supply is

used, but a voltage in the range 18..56V is allowed.

A buzzer can be connected here for fault and alarm

notification. A low voltage type buzzer must be used

that can operate on 3V. Suitable models are the Mallory

PK-20A35EWQ or Alan Butcher Components ABI-004-

RC.

1.2.2 Microphone/PTT key connection

(2)

This 6-pin connector provides the connection for a

microphone and a PTT key. The following dynamic

microphones are suited for use with the module:

• LBB9081 Hand-held Dynamic Microphone

(including resistors for switch supervision).

• LBB9082 Gooseneck Dynamic Microphone.

For the selection of the microphone type, a jumper on

X149/X150 is used. To get access to this jumper,

remove the top cover (see also section 3.3). For the

location of X149 and X150 on the PCB see figure 1.13.

Jumper settings:

Microphone selection via

configuration webpage

Dynamic microphone

Electret microphone

table 1.1: Back-up supply/buzzer connector details

Pin Signal

1 Back-up supply (+)

2 Back-up supply (GND)

3 Buzzer (+)

4 Buzzer (-)

table 1.2: Microphone/PTT key connector details

Pin Signal

1Mic +

2 GND

3Mic -

4 --- not connected ---

5 PTT input contact

6 GND

figure 1.4: LBB9081 connection diagram

10k:

blue

black

red

white

black

(thick)

figure 1.5: LBB9082 connection diagram

black

white

red

1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

Comentarios a estos manuales

Sin comentarios

Bosch CS 150 RC Manual de instrucciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Bosch CS 150 RC