Bosch D9000, G Guía de usuario descargar pdf (Pagina 16)

 Galaxy Interface Manual for Bosch G-series Alarm Panels 

Page 16 of 39

2.5 Adding an Alarm Panel Area

The Alarm Panel Area should be added in the System Galaxy software. The programming must match

the Alarm Panel Area configuration. An alarm panel area consists of 1 or more points

After Panel, Areas and Points are added, System Galaxy can begin receiving status events from the

alarm panel. (Note the alarm panel connection must be maintained). The alarm panel events are

displayed in the Alarm Panel Event screen.

1. open the Alarm Panel Areas Property screen (Configure>Hardware>Alarms>Alarm Panel Areas)

2. pick the desired alarm panel name from the Select Alarm Panel droplist

3. click the Add New button and set the following fields as needed:

 Name field: type a descriptive name (preferably that matches the panel)

 Area Number: enter the area number that matches the area in the alarm panel

(1-8)

 Show in Tree: the show in tree checkbox allows Alarm Panel Area Icon to display in the

System Galaxy Hardware Tree.

4. click the Apply button to save changes

NOTE: The SG Hardware Tree may need to be refreshed to pick up the Area Icon. To refresh

the hardware tree, simply close the tree’s window pane by clicking the [x] button at the

top and reopen it from the SG View menu (select View>Hardware Tree).

NOTE: The Alarm Panel Area Icon will display under the specific Alarm Panel Icon to which it is

assigned. Expand the Alarm Panels Icon, and then expend the Alarm Panel Icon to see

the Alarm Panel Area Icon.

Alarm Panel Area Property screen (cropped)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 38 39

Sin comentarios

Bosch D9000, G Guía de usuario Pagina 16