Bosch DS7400XiV4-EXP Especificaciones descargar pdf (Pagina 109)

DS7400XiV4-EXP | Reference Guide | 7. Reference Materials EN | 109

Bosch Security Systems | 1/05| 4998154963B

7. Reference Materials

7.1 Addressing Multiplex Zones

This section does not apply to the following

multiplex devices:

• DS7457i/DS7457iF

• DS7460i

• DS7461i

• DS7465i

See the documentation for these devices

for addressing instructions.

Before installing a multiplex device, its address and

other information must be entered into the control

panel.

If you are using a DS7436 Multiplex

Expansion Module, program it using Bus A.

7.1.1 Control Panel Setup

Before a multiplex device address can be entered into

the control panel, the control panel must be properly

programmed. See Programming a Zone on page 31 to do

the following:

1. Assign a zone number

2. Assign a zone type

- Single zone input

- Multiple zone input

- DS7465 input/output module

- Multiplex smoke detector

- Multiplex smoke detector with low temperature

alarm

3. Assign which zone function or output function the

multiplex zone follows

4. Assign an area/partition to the multiplex zone

For example, the following steps show how to program

Zone 9 as a single zone input device (MX950) that

follows Zone Function 1 and is assigned to

Area/Partition 1.

1. Enter the programmer’s mode.

2. Enter Address 0039.

3. Press [0][1][#] to program Data Digits 1 and 2

(Data Digit 1 = 0; Data Digit 2 = 1).

4. Enter Address 0291.

5. Press [0][0][#] to program Data Digits 1 and 2

(Data Digit 1 = 0; Data Digit 2 = 0).

6. Exit the programmer’s mode.

7.1.2 Multiplex Device Setup

When the control panel is properly set up for

multiplex zones, you can begin programming

multiplex devices.

1. Disconnect all multiplex devices from the DS7430.

2. Program the multiplex devices from the control

panel.

a. Enter the programmer’s mode.

b. Enter the multiplex programming mode by

pressing [9][9][9][5][#].

The control panel checks the multiplex

connection to confirm that nothing is

connected. The text keypad shows:

Checking

Multiplex Bus

The display then scrolls to the first zone you

entered as a multiplex zone.

To scroll to a different zone, press [Reset/*],

and then enter the desired three-digit zone

number. The text keypad shows:

Sens/Contact 009

Press # to Prog

c. Reconnect the multiplex device that coincides

with the displayed zone to the DS7430.

d. Press [#] to enter the device into the control

panel.

If you are programming a DS7465 or a

multiple input device, these device types

require two zone addresses. For example, if

Address 009 is assigned to a DS7465, the

DS7465 will also occupy Address 010 when

you press [#].

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 143 144

Comentarios a estos manuales

Sin comentarios

Bosch DS7400XiV4-EXP Especificaciones Pagina 109

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch DS7400XiV4-EXP