Bosch LTC 1271 Series Manual de instalación descargar pdf (Pagina 7)

C2431M-I (4/07) 7

Figure 2. TXB-B Termination and DIP Switch

6. Set the address of the TXB-B (refer to Table C, Table D, and Table E in the Appendix beginning on

page 25).

7. Install the TXB-B on the Esprit circuit board (refer to Figure 3):

a. Insert the 16-pin connector on the bottom of the TXB-B into the mating 16-pin connector on

the Esprit circuit board.

b. Reinstall the nut and washer on the standoff to secure the TXB-B to the Esprit circuit board.

Figure 3. Installing the TXB-B into the Esprit

8. Set the DIP switches on the Esprit system (refer to Figure 1 for switch location):

a. SW1: Set all SW1 switches to the OFF position.

b. SW2: Set the Espirt address (refer to Table E on page 43 of the Appendix for switch settings).

9. Reinstall the left cover of the pan and tilt:

a. Properly position the cover and slide it into place. The sides of the cover must fit under the

front and back rain guards of the pan and tilt. The top of the cover must seat against the lip of

the top gasket. (Refer to Figure 4.)

WARNING: Make sure you seal the unit. Otherwise, moisture could disable or damage the Esprit.

16-PIN CONNECTOR

TXB-B

ADDRESS

SWITCH

J1 RESET FOR LOOPING (UNTERMINATED)

OPERATION

FRONT BACK

J1 TERMINATED

J1 UNTERMINATED

STANDOFF

16-PIN CONNECTOR

STANDOFF NUT

AND WASHER

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Sin comentarios

Bosch LTC 1271 Series Manual de instalación Pagina 7