
FlexiDomeHD 720p Camera Installation | en 33
Bosch Security Systems Installation and Operation Manual AR18-10-B013 | v1.52 | 2010.12
5.4 Camera positioning
The physical default position of the camera is that the bottom
of the image corresponds to the indication BOTTOM on the
housing.
The camera module position can be adjusted along three axes.
When adjusting the camera position ensure that the picture
display on the monitor is level. Set the camera to the desired
position by performing the following steps:
– For horizontal adjustment (pan), rotate the camera module
in the base. Do not rotate more than 360°.
– For vertical adjustment (tilt), loosen thumbscrews,
position camera, then gently tighten thumbscrews to
secure camera. Do not rotate more than 90°.
Comentarios a estos manuales