Bosch D7212GV2 Guía de instalación descargar pdf (Pagina 39)

D7212GV2 | Operation and Installation Guide | 9.0 Off-Board Points

Bosch Security Systems, Inc. | 2/07 | F01U003805-02 39

The D8128D is also suitable for fire supervisory

applications, such as indicating circuit supervision

(using the D192G Bell Circuit Supervision Module),

sprinkler supervision, and valve tamper protection.

Use the D125B for two-wire smoke

detectors.

The D129 is usually used for water-flow

switches.

Figure 17: D8128D OctoPOPIT Layout

23451 678

P O I N T S

1 - Molex

connectors

2 - Address DIP switches

3 - Terminal strip

4 - Point DIP switches

9.4.3 Installation

For the most effective installation, use the following

four-step process:

1. Set the OctoPOPIT switches. Refer to Section 9.4.4

Setting the OctoPOPIT Switches.

2. Physically mount the OctoPOPIT in the enclosure.

Refer to Section 9.4.5 Mounting OctoPOPITs on page

40.

3. Wire the OctoPOPIT. Refer to Section 9.4.6 Wiring

OctoPOPITs on page 40.

4. Wire the OctoPOPIT sensor loops. Refer to Section

9.4.6 OctoPOPIT Sensor Loops on page 43.

9.4.4 Setting the OctoPOPIT Switches

The D8128D OctoPOPIT has two sets of DIP switches

(Figure 17). Use the DIP switches on the top of the unit

(with the terminal strip along the left edge) to set the

address for the OctoPOPIT. Use the DIP switches at

the bottom of the unit to enable or disable individual

points connected to the OctoPOPIT.

Address Switches

The switches on the D8128D OctoPOPIT set point

assignments and line termination. These switches are

easier to set before mounting the D8128D in the

enclosure.

Switches 1, 2, 3, and 4 assign the OctoPOPIT sensor

loops to point numbers on the control panel. Table 14

shows the OctoPOPIT switch settings for point

assignments.

Switch 5 sets line termination. Refer to Table 15.

Table 14: D8128D OctoPOPIT Switch Settings

ZONEX 1 D8128D Address Switches

Points 9 to 40 1 2 3 4 5

9 to 16 ON ON ON ON *

17 to 24 ON ON ON OFF *

25 to 32 ON ON OFF ON *

33 to 40 ON ON OFF OFF *

* Line Termination Switch

The D7212GV2 uses Points 9 to 40 on

Zonex 1 only.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 59 60

Comentarios a estos manuales

Sin comentarios

Bosch D7212GV2 Guía de instalación Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch D7212GV2