Bosch D7212GV2 Guía de instalación descargar pdf (Pagina 51)

D7212GV2 | Operation and Installation Guide | 13.0 Programmer Connections

Bosch Security Systems, Inc. | 2/07 | F01U003805-02 51

12.5.2 Network Interface Modules

The Bosch Security Systems, Inc. DX4020 Network

Interface Module is a four-wire powered SDI device

that provides connection for two-way communication

over Ethernet networks to the D7212GV2.

For programming information on enhanced

communications, refer to the D7212GV2 Program Entry

Guide (P/N: F01U003804).

The DX4020 can be installed up to 305 m (1000 ft)

from the control panel using 0.8 mm (22 AWG) wire.

The D9133TTL-E can be installed up to 305 m (1000

ft) from the control panel using 1.2 mm (18 AWG)

wire.

12.5.3 Address Settings

The DX4020 has specific DIP switch settings for SDI

Address 88 when using the DX4020 for Remote

Programming Software (RPS) or enhanced

communications in a local area network (LAN) or

wide-area network (WAN) environment. Refer to

Figure 26 for the correct switch settings.

Figure 26: DX4020 DIP Switch Settings

OPEN

123456

1 - DIP Switches

2 - ON position

3 - OFF position

4 - SDE Address 88 switch settings

12.5.4 Supervision

Supervision of the DX4020, D9133DC, and

D9133TTL-E at SDI Address 88 is available through

programming that ensures operation between the

module and the control panel.

If supervised and the module does not respond to

control panel supervision polls,

SERVC SDI 88

appears at the keypad. The report to the receiver

includes the address of the troubled module indicating

which module needs service.

13.0 Programmer Connections

13.1 Programmer Connector

Refer to the D5200 Operation Manual

(P/N: 74-06176-000) for complete information on using

the D5200 programmer.

To connect and disconnect the programmer:

Lock the Reset Pin (Figure 27).

Connect the D5200 Data/Power cord to the

programming connector on the control panel.

Perform the desired programming function (send

or receive program).

Disconnect the programmer.

Figure 27: Reset Pin

Reset Pin

Disable All Except Battery

Charging And Programming

PERIPHERAL DEVICE CONNECTIONS

RED POWER +

YELLOW DATA BUS A

GREEN DATA BUS B

BLACK COMMON

1 - Reset Pin locked (closed)

2 - Reset Pin normal (open) for normal control

panel operation

13.2 Programmer Access Reports

When a program is sent to the control panel, the

control panel sends a

Prog Access OK report ten

seconds after the handler exits or when the

programmer disconnects. The prompt in routing must

be programmed Yes to send this report.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 59 60

Comentarios a estos manuales

Sin comentarios

Bosch D7212GV2 Guía de instalación Pagina 51

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch D7212GV2