Bosch SC8016 Guía de instalación descargar pdf (Pagina 27)

SC9000

ST150 SAFECOM Central Station Operations Manual

•

Panel Arm XLAT assigns the Panel Arm output to one of the 80 output translation lines.

•

Output1 XLAT assigns the specified control to one of the 80 output translation lines.

NOTE: See SYSTEM OUTPUT for more information.

•

Output XLAT - 00 to 4F: The Output Translation Table (XLAT) specifies the English plain text definition that you wish

to assign to an OUTPUT. The text will be displayed in place of the default messages “Enabled” or “Disabled”. The

Output Translation Table has 5 pages, with 16 line numbers per page, for a total of 80 line numbers. Each line

provides a maximum of 8 characters for English text translation for Enable and Disabled Output conditions. The

corresponding text assigned to the respective Output in the translation table is only for display at the SC9000

computer. It is not part of the message sent to the Automation software. Output translation gives the operator the

ability to allow an Output on SC8016 to report “PUMP ON” or “PUMP OFF” instead of “OUTPUT ENABLED” or

“OUTPUT DISABLED”. This ability can be very useful for remote control applications. Each translation table (XLAT)

line contains two available conditions that the operator must define, “ENABLED” & “DISABLED”.. These are the only

conditions an SC8016 output can be in and report.

NOTE: The SAFECOM ST150 v1.00 and higher software default values for all new Radio Communicator outputs are “ 00

“ and the default values for line #00 in the Output Translation Table are enabled and disabled.

4.2.3 Remote Status Display-the SC8016 Radio Communicator’s Response to a Manual “Poll” by the

Operator.

If the central station operator performs a manual poll of a Radio Communicator, the remote status display comes up on

the screen to show the operator the exact status of the Radio Communicator in the field. The Remote Status display

allows the operator to individually control and monitor the status of a SC8016. The following is a description of those items

available for viewing and control on the Remote Status display

(See the diagram below and the explanation following):

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Sin comentarios

Bosch SC8016 Guía de instalación Pagina 27