
Information concerning the accessibility of all interfaces and nodes within the system
network.
– Ethernet ports
Information concerning various parameters and the status of the two Ethernet interfaces
available at the panel controller.
– Send ping command
Sending of a ping command to a specific IP address to check the availability of other
nodes in the network.
– Consistency check
The check performed determines whether the Ethernet configuration from FSP-5000-RPS
corresponds to the configuration entered at the panel controller. In the event of
discrepancies, a fault message is displayed.
– Ethernet redundancy
Information concerning the type of redundancy configuration (RSTP or dual-homing). In
the case of redundancy via RSTP, the RSTP parameters of the RSTP panel (local bridge)
and those of the root bridge are displayed.
VAS
Information on all connected electro-acoustic systems that are used for voice evacuation
systems.
Maintenance
Maintenance -> Walktest Change language
Activate outputs Activate transmission device
Remove detector History log
Change device at V.24
interface
Bypass buzzer
Walktest
Start / End walktest
Elements for the walktest are selected in this submenu. The following possibilities are offered
for selection:
– Select by number:
Display of a list of all elements:
Search for an element in a list by entering the number.
– Walktest group
– Loop
– Logical zone
– Elements
– Transmission device
– Control element
– More...
– DACT
– Key deposit
– Battery
– Mains power
When the walktest is complete, the following selection options are available:
– Adding the elements to be tested to a different walk test group (Assign tested elements
to walktest group).
3.4
3.4.1
14 en | All functions at a glance Panel Controller
2013.07 | 3.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
Comentarios a estos manuales