
Configuration
Configuration -> Set input / output
groups
Set groups
Detector sensitivity Operator
Rename elements Overview
Network
Set input / output groups
– Input group or Output group
– Displaying the assigned elements.
– Add or delete elements.
– Rename group names.
Set groups
– Bypass group, isolate group or walktest group
– Displaying the assigned elements.
– Add or delete elements.
– Rename walktest, bypass and isolate groups.
Detector sensitivity
Change the sensitivity of individual detectors or zones. Two selection options are available: a
default sensitivity and an alternative sensitivity assigned in the FSP-5000-RPS programming
software.
Operator
If the same password is used per access level, the following options are offered:
– Change universal password
The same password can be configured for each access level in the FSP-5000-RPS
programming software. The password for access levels two to four can be changed.
If every user has a different password, the following options are offered:
– Change operator data
Change a user's password.
– Set default password
Reset an operator's password to his/her previous password.
Rename elements
Change the description of the elements.
Overview
Information on valid system configuration.
Network
Change and activate network settings (IP settings, Ethernet redundancy). Changes take effect
after restarting the panel.
Notice!
Changes may only be made by trained specialist personnel. Competent knowledge of
networking and protocols is essential!
Switching to day or night mode
– Switch to day or night mode
– In day mode: Set the reset time to night mode for the current day.
3.5
3.6
16 en | All functions at a glance Panel Controller
2013.07 | 3.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
Comentarios a estos manuales