Bosch FPA-1200-MPC Guía de usuario descargar pdf (Pagina 81)

4 Select Switch to day mode to confirm the request or Cancel to cancel the operation.

The panel is in day mode. To switch it to night mode:

4 Press

4 Select Switch to night mode to confirm the selection or Cancel to cancel the operation.

Showing details

It is possible both in day and night mode to display a list of all logical zones on the panel that

are currently switched to day mode.

To display a list of all detector groups in day mode

1. In the start menu, select Switch to day mode or Switch to night mode, depending on

which mode the panel is currently in, or select the "day mode" or "night mode" icon on

the status bar.

2. Select Show details.

A list of all logical zones that are switched to day mode is displayed.

Changing the time for resetting to night mode

Caution!

After the system starts up following a power cut or battery failure, the default set back time

in FSP-5000-RPS is reset.

Notice!

Depending on the configuration, the set back time can be changed. It is only possible to make

a change for the current day. It is only possible to make a change if a specified time has

already been set for the current day in the programming software.

The set back time can be changed in day or night mode.

To change the time for resetting in night mode:

1. On the status bar, select

In the start menu, select Switch to day mode.

2. Select Change time.

3. Enter the numbers you require.

Refer to Entering numbers and text, page 30 for information on how to enter numbers.

4. Select OK to confirm the entry or Cancel to cancel the operation.

The entries are confirmed.

18.2

18.3

Panel Controller Day and night mode | en 81

Bosch Sicherheitssysteme GmbH User Guide 2013.07 | 3.0 | F.01U.258.929

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 99 100

Sin comentarios

Bosch FPA-1200-MPC Guía de usuario Pagina 81