Bosch AMAX panel 2000 ICP-AMAX-P Manual de instalación descargar pdf (Pagina 51)

AMAX panel 2000 / AMAX panel 2000 EN System Informations 1 | en 51

Bosch Sicherheitssysteme GmbH Installation Manual F.01U.241.127 | V4 | 2011.12

EEE = Event Code

GG = Group Number (always 0)

CCC = Zone/ Contact ID, 000 is for no zone/ID message

S = Checksum digit

Note: Any 0 values must be sent as an 0x0A.

Contact ID Report Data:

7.6.3 CFSK Format

The CFSK communication format is a protocol based on the standard Bell 103 FSK (Frequency

Shift Keying) modulation, as detailed by the SIA (Security Industry Associaton) “Digit

Communications Standard” November 1991.

CFSK Message Format(6/2)

B AAAAAA TE S

B = Begin ( 1 byte, always 04 )

AAAAAA= Subscriber ID (3 bytes)

T= Type of Event Code ( 1 byte)

E= Event/User/ Zone number (1 byte)

S= Checksum digit (1 byte)

Formular S = Sum of message bytes & 0xFF

Remark:

7.7 Dialer Information

This section outlines the programming information required for the AMAX panel 200 / AMAX

panel 2000 EN when communicating with a base station receiver. These parameters specify

the telephone numbers/IP address to be called, transmission formats and internet

communication options.

The control panel can report event information from four on-board dialers. The dialers report

to Receiver 1 to Receiver 4 by programming. You can program each dialer with 4 separate

telephone numbers/IP addresses and ports, reporting format type and subscriber ID number,

and internet communication options if necessary.

Example

You can set up Dialer 1 to report to receiver 1 in CFSK Format and set up Dialer 2, Dialer 3 and

Dialer 4 to report to a base station receiver in Contact ID Format only if Dialer 1 is

unsuccessful.

To program a telephone number:

Each location in the telephone numbers stores one digit of the telephone number.

Insert a 15 at the end of a telephone number to indicate to the dialer that the end of the

telephone number is reached. The dialing sequence is terminated when a 15 appears.

Example

To program the telephone number 9672 1055 as the Telephone Number for Receiver 1,

program the following sequence into Location 000 - 016:

[9 6 7 2 1 0 5 5 15 x x x x x x x x]x stands for any digit.To enter a 4-sec pause in the

dialing sequence, program a 13. A pause might be necessary when the dialer communicates

through an old (slower) telephone exchange or when a PABX system is in place.

Example

To program the number 02 pause 9672 1055, enter:

[0 2 13 9 6 7 2 1 0 5 5 15 x x x x x].

Table 7.1 shows how to program the numbers, keys, and functions for a telephone number.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 91 92

Comentarios a estos manuales

Sin comentarios

Bosch AMAX panel 2000 ICP-AMAX-P Manual de instalación Pagina 51

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch AMAX panel 2000 ICP-AMAX-P