Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones descargar pdf (Pagina 12)

wLSN | Reference Guide | 2.0 General Installation

12 Bosch Security Systems, Inc. | 3/07 | F01U009440-01

You must test the devices at the same EN50131 Security

Grade at which the control panel discovers the devices.

4. Find a suitable location for the hub base and apply power by

either connecting it to the control panel (refer to the control

panel’s installation instructions), or temporarily connecting a

9 VDC to 12 VDC battery.

5. Insert the wLSN Hub back into the base. Rotate the

enclosure locking mechanism to the locked position.

6. Proceed to the appropriate procedure:

- Section 2.4.2 RFSS Testing Between wLSN Hub and

Device

- Section 2.4.3 RFSS Testing Between wLSN Hub and

Installation Tool on page 14

You must use the Installation Tool with the wLSN Smoke

Detector. You cannot determine RFSS with the detector

itself.

2.4.2 RFSS Testing Between wLSN Hub and Device

1. Take the device being tested to its planned mounting

location.

2. Remove and re-insert the batteries of the device, then

quickly press and release the tamper switch button (refer to

Figure 1 on page 13) four times to enter RFSS mode.

You must enter RFSS mode within 10 sec of re-inserting

the batteries.

When RFSS mode is enabled, the LED lights steadily for 5 sec,

then flashes.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Sin comentarios

Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones Pagina 12