Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones descargar pdf (Pagina 15)

wLSN | Reference Guide | 2.0 General Installation

Bosch Security Systems, Inc. | 3/07 | F01U009440-01 15

4. Hold the Installation Tool at the device’s planned mounting

location.

Use Mode 1 to determine if the signal strength is acceptable

or not. Modes 2 and 3 help you determine how acceptable

the signal strength is. Use Modes 2 and 3 to place the wLSN

Hub and device in the best signal strength locations.

Refer to Mode 1, Mode 2 (page 16), and Mode 3 (page 17) for

more information on acceptable signal strength levels.

If the RFSS is unacceptable, reposition either the wLSN

Hub or the Installation Tool until an acceptable location is

found.

5. Repeat this procedure for each device’s location you are

testing. When you finish testing locations, return the wLSN

Hub’s switches to their original position.

The Installation Tool automatically exits RFSS Mode 30

min after the last key press. You can also press and hold

the [*] and [#] keys together to exit RFSS Mode. The

Installation Tool powers down from the main menu 30 sec

after the last key press.

Mode 1

Select Mode 1 by pressing [1]. If the RFSS is acceptable the LCD

shows:

If the RFSS is unacceptable the LCD shows:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Sin comentarios

Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones Pagina 15