Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones descargar pdf (Pagina 57)

wLSN | Reference Guide | 14.0 wLSN Glassbreak Detector

Bosch Security Systems, Inc. | 3/07 | F01U009440-01 57

14.4 Low Battery Indication

The detector indicates a low battery condition in two ways:

• If the LEDs are enabled, both flash simultaneously every sec.

• A battery status indication is sent to the control panel.

The LED flashing and a low battery indication at the control panel

are independent of each other and do not necessarily occur at the

same time. Receiving either condition indicates a low battery.

14.5 Wall Tamper Tab

14.5.1 Entering RFSS Mode

To enter RFSS Mode if the wall tamper tab is removed:

1. Take the detector to its planned mounting location.

2. Remove and reinsert the batteries.

3. Press and hold the wall tamper switch. Refer to Figure 22.

4. Quickly press and release the cover tamper switch four times

within 10 sec of reinserting the batteries. Refer to Figure 22.

The detector enters RFSS Mode.

Figure 22: Wall and Cover Tamper Switches

ID:000000000

RF1100E

1 - Wall tamper switch (back of detector)

2 - Cover tamper switch (inside of detector)

1 2 ... 52 53 54 55 56 57 58 59 60

Sin comentarios

Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones Pagina 57