Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones descargar pdf (Pagina 19)

wLSN | Reference Guide | 2.0 General Installation

Bosch Security Systems, Inc. | 3/07 | F01U009440-01 19

2.6 Battery Requirements

Dispose of used batteries according to manufacturer’s

instructions.

When you insert batteries into a wireless device, the LED turns on

for approximately five sec to indicate that battery strength is

sufficient. If the LED does not turn on, replace the batteries.

On the Recessed Door-Window Contact (ISW-BMC1-

R135X), the LED is on the internal printed circuit board.

Refer to Figure 10 on page 34 for the location of this LED.

On the Inertia Detector (ISW-BIN1-S135X), the LED turns

on for 0.5 sec to indicate sufficient battery strength.

On the Glassbreak Detector (ISW-BGB1-SAX), the Alarm

and Event LEDs turn on for approximately 0.5 sec. The

RFSS Mode LED turns on for approximately 5 sec. Refer

to Figure 19 on page 51 for the location of these LEDs.

For the wLSN Smoke Detector, refer to Section 13.1 Battery

Replacement on page 44 for more information.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 59 60

Sin comentarios

Bosch ISW-BIT1-HAX WLSN INSTALLATION Especificaciones Pagina 19