Bosch K2200 Series Guía de usuario descargar pdf (Pagina 19)

K2200 Series | User Guide | 4.0 Key Administration/ Access Control EN | 19

Bosch Security Systems | 7/03 | 17376 v1.1 / 47491C

•

0101

Instead of voiding a key from the system,

consider changing its access code to 0

(zero). By doing this you will prevent use

of the key (any attempt will result in a No

Access: Locked Out transaction being

generated) but you will also have a record

of a 'lost' key being used unsuccessfully

To Void a Key:

1. Present an editor key to the faceplate reader.

2. Enter the password and press [ENT], if required.

3. You will now see the CMD prompt.

4. Type [V] and press [ENT].

CMD V_

5. At the ID Prompt,

ID _

you can select the key to be deleted using one of

these methods:

- If you are in possession of the key itself,

present the key to the faceplate reader.

If the key is not in the database, you

will get a message for about 2

seconds

NOT IN DATABASE

before returning to the ID prompt.

- Type the 4-digit ID of the key and press

[ENT]. Any number between 1 and 4000

will be accepted.

- If you are using 12-character IDs, you

can type the ID and press [ENT]. You

must type the name exactly as it was

originally entered. If no match is found,

you will get a message

UNKNOWN NAME

for about 2 seconds before returning

to the ID prompt.

6. Whatever method you use to find a key, you will

be presented with the ID number and access

code.

ID 27 AC 7

7. At this point, you can use the up and down

arrow keys to move through the database to find

the key you want to delete. You can also press

the FastFind (*) button to return to the ID

prompt.

WHO SMITH AB

8. Once you have selected the key you want to

delete, press [ENT].

9. At the CONFIRM VOID prompt,

CONFIRM VOID

press [Y] to confirm and you will be returned to

the CMD prompt. Any other key will return you

to the CMD prompt without voiding the key.

When a key has been voided, it will be rejected by

all the readers on the system and a

No Access: Unknown ID transaction will be

produced. This will not be the case if:

• Slave door controllers are disconnected or not

communicating with the master.

• A download is in progress to a slave door

controller, in which case the new information

will not reach the slave until completion of the

download.

4.1.4 Editing Keys – The E Command

You can change the access code of a key as well as

the 12-character name (if used) at any time. You can

also assign a holiday profile to a keyholder. The

access code and holiday profile must already be

defined (see Section 4.2.6 Access Codes – The AC

Command and Section 4.2.7 Holidays – The HR and HP

Commands).