
K2200 Series | User Guide | 5.0 Displays, Alarms, and Printing EN | 33
Bosch Security Systems | 7/03 | 17376 v1.1 / 47491C
Table 15: Print Report Commands
Command Description
P1
Personnel
P2
Door Data
P3
Access Codes
P4
System Status
P5
Transactions
P6
System Set up
P7
Alarm Data
P8
Time Profiles
P9
Holiday Profiles
The P2, P4 and P6 commands will start printing
immediately; for other commands, see below.
5. The commands P1, P3, P7 P8 and P9 ask for a
FROM and TO parameter.
PRINT FROM 1
PRINT TO 4000
(P1 – Personnel)
The default values are FROM 1, and TO the
highest value (P1: 4000, P3:128, P7: 128, P8: 32,
P9: 24).
Press [ENT].
Press [NXT] to go to the TO field.
Press FastFind (*) at any point to accept the
entered values and start the report.
6. P5 – Transactions - asks for a start date and
time plus an end date and time. The defaults are
the earliest possible date and time and the
current date and time.
STRT DT 00-00-00
STRT TIME 00-00
END DT 11-11-93
END TIME 17-13
Use [NXT] to enter any other date and time as
the report range.
Press [ENT] after making any changes.
Press FastFind (*) at any point to accept the
entered values and start the report.
7. Printing - If the printer is connected, a scrolling
display will appear indicating that the report is
being printed.
*PRINTING PERSON
Press [ESC] at any time to abort the printout.
Note:
The personnel (P1) may appear to spend a long time
showing this display but not printing. This is because it
examines all 4000 possible keyholders for valid entries,
unless the upper limit is reduced
8. Failure to Print - If the printer is not connected
or out of paper, you may get this message, plus a
short beep.
PRINTER FAULT
Reconnect the printer or fill it with paper and try
the command again.
Comentarios a estos manuales