Bosch LTC 2604 Manual de instrucciones descargar pdf (Pagina 34)

IntuiKey Series | Instruction Manual | Controlling System4 Video Multiplexers

Bosch Security Systems | 28 June 2004

6.2 Programming/Controlling MUX

Functions

6.2.1 Password Entry

If a password is required by the multiplexer on-screen

display, you must press ENTER after each number entered for

the password (e.g. if the password is 1-2-3-4, you then press

1, then ENTER, 2, then ENTER, etc.).

FIGURE 6-2 System4 Mux Main Control Menu

6.2.2 MUX Main Control Menu Command

Descriptions

The MUX Main Control menu, displayed on the softkey

display, uses the softkey buttons to execute commands or

to gain access to other submenus for additional

programming/configuration. Detailed command

descriptions follow. Refer to the Multiplexer

Instruction Book for additional information.

Exit

Exits one menu and returns to the main menu for

the particular function being programmed.

Full Screen

Select Full Screen Camera Mode by pressing the Full

Screen softkey. The camera currently selected by

the keyboard will be displayed in full screen on the

monitor.

Quad Screen

Divides the screen into four separate areas. Enable

Quad Screen Mode by pressing the Quad Screen key

once. Pressing the key additional times cycles

through different viewing configurations.

Multiscreen

Enables multiscreen displays. The capabilities of

the multiplexer model under control determine the

available configurations.

• 6-channel: 5+1

• 9-channel: 4+3, 3x3

• 16-channel:4+3, 8+2, 12+1, 3x3, and

4x4

NOTE: Pressing the multiscreen softkey multiple times

cycles through the possible selections.

Select Cameo Segment

When in Multi or Quad Mode, the screen area where

a camera is displayed is called a cameo. Press the

Cameo softkey to enter the cameo selection mode.

In this mode, joystick is used to select which cameo

window will be under control of the keyboard.

Entering a number into the keyboard while in this

mode will cause the camera to appear in the

currently selected cameo window. Cameras may be

assigned to any selected cameo, and may be

changed as often as required. The Intuikey’s

numeric entry field title will change to Cameo while

the DVR is in this Mode. Press the Cameo softkey

again to exit the mode.

NOTE: The multiplexer function of Assigning All

Cameras is provided by an additional softkey on the

MUX Main Control menu. Press this key to activate this

function.

Sequence

Runs a previously programmed camera sequence.

Toggle VCR Test Mode

Enables/disables the multiplexer’s VCR test mode.

When in VCR test mode, the IntuiKey status

display shows the VCR icon.

Record

Activates VCR record mode and displays the REC

indicator in the IntuiKey status display. Press the

softkey again to disable the record mode.

Play

Activates VCR play mode and displays the PLAY

indicator in the IntuiKey status display. Press the

softkey again to disable the play mode.

Exit Record

Full

Screen Play

Quad

Screen ZOOM

Multi

Screen Freeze

Select Recorder

Cameo Controls

Segment

Camera

Sequence Control

Toggle MUX

VCR Control

Te xt Mode

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

Comentarios a estos manuales

Sin comentarios

Bosch LTC 2604 Manual de instrucciones Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch LTC 2604