Bosch LTC 2604 Manual de instrucciones descargar pdf (Pagina 36)

IntuiKey Series | Instruction Manual | Controlling System4 Video Multiplexers

Bosch Security Systems | 28 June 2004

EN

|

36

a. Exit

Exits the present menu, reverting to the previous

menu.

FIGURE 6-6 On-screen Control Menu

b. On-screen Control Menu

Provides access to the multiplexer’s on-screen

display (OSD), if the access level has been

enabled to FULL ACCESS (otherwise, the

softkey display indicates that the present user

level is not high enough for this level of access).

If the current user level does not allow the

operation, a warning message is displayed, and

control reverts to the MUX Control submenu.

The warning message clears and reverts to the

MUX main control menu in approximately two

(2) seconds or after pressing CLR.

NOTE: To change the access level, refer to (d)

User Level.

The on-screen control menu provides softkey

access to the following multiplexer functions:

• Exit: ZOOM

Exits to one level higher when in menu mode.

• Choose: SELECT

Used when the OSD prompts to choose a

selection.

• Save: SELECT

Used when the OSD prompts to save the

current selections.

• Default: FREEZE

Changes an entry to its default state.

• Help

Displays the MUX’s internal help file associated

with the present OSD selection.

• Up ^

Moves the OSD cursor up one line.

• Down

Moves the OSD cursor down one line.

• < Left

Moves the OSD cursor to the left one position.

• Right >

Moves the OSD cursor to the right one

position.

• Enable/Disable

Used in Set Action Zones in Action Setup menu.

c. Find Muxes

Polls each mux address for a response. If a

response is found, an ON indicator is displayed

next to the mux address. Exit by pressing any

key.

d. User Level

This softkey is used to change the current User

Level. (The current setting is displayed on the

softkey.) User Levels can be used to limit access

to certain multiplexer features, including access

to the on-screen configuration menu. To change

the current User Level, press the softkey to

enter the password entry mode. Enter the

keyboard password (refer to APPENDIX C)

within two (2) seconds. Select the desired User

Level, as listed on the softkey menu.

NOTE: The selected User Level applies to all

multiplexer devices connected to the IntuiKey.

e. Quick Keys

Allows access to the multiplexer’s quick key

commands. If the current user level does not

allow the operation, a warning message is

displayed, then clears and reverts to the MUX

main control menu (approximately two (2)

seconds or after pressing CLR). Refer to the

Multiplexer Instruction Book for additional

information on the quick key functions.

^

Exit: Help:

ZOOM ALT

Default:

^ Up FREEZE

< Left Right >

v Down Enable/

Disable

Choose: Save:

SELECT SELECT

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comentarios a estos manuales

Sin comentarios