Bosch SE2005 Guia de preparacion descargar pdf (Pagina 10)

Security Escort | Installation and Setup Guide | 1.0

S

y

stem Overview

EN | 10

Bosch Security Systems | 1/09 | 33831E

• Power output: 9 VDC output for

SE485 or for ProxLink Radio Module

power

• Driver outputs:

- Strobe: 500 mA solid state sink,

terminal switches to ground in

an alarm condition.

- Siren: 500 mA solid state sink,

terminal switches to ground in

an alarm condition.

• Multiplex buses: eight multiplex

driver buses for power and

communication to receivers or alert

units

• Communication interface to central

console: selectable SE485 or RS-232

• Keyswitch input: Optional 47k EOL

resistor, supervised loop

1.3.4 EA102 Receiver

Description

The EA102 Receivers are located

throughout the grounds and building

interiors. Each receiver contains a

radio receiver to detect the

transmissions from transmitters.

Multiple receivers detect the same

transmission and send the signal

information to the transponder so the

system can identify the transmitting

device, transmitting information, and

location. The receiver also reports

housing tampering and radio jamming to

the transponder.

Indoor receivers are typically mounted

on inside walls and have one red and

one green LED. The green LED is used

to indicate a successful Test of a

personal transmitter. The red LED is

illuminated during alarms. Each

receiver contains a piezo-electric

horn that can be activated if the

receiver detected an alarm

transmission

Outdoor receivers are contained in

small weatherproof boxes typically

mounted on the sides of buildings and

on light posts. Outdoor receivers do

not have the visible red and green

LED’s. Outdoors, the strobe lights on

the alert units should be used to

acknowledge successful test and alarm.

Specifications

• Enclosure:

- Indoor: AE100 indoor enclosure

- Outdoor: AE101 outdoor enclosure

• Temperature range: -40°C to +65°C

(-40°F to

+149°F)

• Power source: 12 VDC, 25 mA

typical, 55 mA with horn sounding,

supplied from the transponder MUX

bus

• Antenna type: Diversity antennas

protected within enclosures

1.3.5 EA120 Alert Unit

Description

This is a control module that

communicates with the transponder on

the MUX Bus. The alert unit can be

used to activate strobe and siren

units or optional other switched

devices. The alert unit also reports

tampering, AC power loss, and backup

battery level to the transponder.

Specifications

• Enclosures:

- Indoor: AE1 small indoor metal

- Outdoor: AE101 outdoor fiber

• Temperature range: -40°C to +65°C

(-40°F to +149°F)

• Power source: 18 VAC, 50 VA (can

use TR1850, 110 VAC to 18 VAC

transformer)

• Battery backup: 12 VDC lead acid

battery

• Driver outputs:

- Power: 1 A maximum, intended as

the supply source for strobe and

siren

-

Strobe: 500 mA solid state sink,

terminal switches to ground in

an alarm condition

- Siren: 500 mA solid state sink,

terminal switches to ground in

an alarm condition

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Comentarios a estos manuales

Sin comentarios