Bosch SE2005 Guia de preparacion descargar pdf (Pagina 41)

Security Escort | Installation and Setup Guide |5.0 Testing

and Troubleshootin

g

EN | 41

Bosch Security Systems | 1/09 | 33831E

1. Enable the Test Mode by placing the

P4 jumper across both pins (jumper

P5 removed).

• The red LED turns ON and stays

ON during the test. This

indicates that power is properly

connected and the receiver is in

Test Mode. If the red LED does

not come on, check the POWER+

and POWER- wiring to this

receiver. Also verify the

corresponding transponder bus

enable jumper is in place and

the transponder is on and

powered.

• The green LED flickers if the

receiver is connected to a

working transponder. If the

green LED is not flashing verify

the BUS+ and BUS– wiring to this

receiver (note: this is a rapid

flashing).

• There is no data transmitted to

the central station. Therefore

the central console reports this

receiver as “Not responding”

while the receiver is in Test

Mode.

2. Activate the transmitter from

different locations near the

receiver.

• The red and green LEDs respond

to a received transmission.

• If the receiver detected all the

packets from the transmission,

the sounder sounds.

3. Remove the P4 jumper to return the

receiver to normal operating mode.

5.2.3 Receiver Spacing Mode

Refer to Section

2.3.1 Verify Each

Potential Receiver Location to

determine receiver location and

spacing.

5.3 Transponder

5.3.1 Status LEDs

Each transponder contains LEDs that

display the transponder’s condition

and its response to events. With the

exception of the AC Power LED (which

is located in the lower right corner

of the transponder circuit board), the

diagnostic LEDs are located in the top

right corner of the transponder board.

Generally, the LEDs indicate the

unit’s status and signal system

events. Each LED and its function is

indicated in

Table 9:

Figure 20: EA500 Diagnostic LEDs

Bus 0

Bus 1

Bus 2

Bus 3

Bus 4

Bus 5

Bus 6

Bus 7

Comm Fail

Carrier Detect

Transmit Data

Receive Data

CRC Error

Test in Porgress

Alarm in Progress

Heartbeat

1

1- Transponder address

Figure 21: EA501 Diagnostics LEDs

OFF

ON

Comm Fail/Bus Fault

Carrier Detect

Transmit Data

Receive Data

CRC Error

Test in Porgress

A

larm in Progress

Heartbeat

1

2

1 - Transponder address

2 - 12 VDC battery connector

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 53 54

Comentarios a estos manuales

Sin comentarios