
Security Escort | Installation and Setup Guide | 1.0
S
stem Overview
EN | 13
Bosch Security Systems | 1/09 | 33831E
• Operating Voltage: Supplied by a 3
VDC lithium battery.
• Battery Life: Up to five years
under normal usage with the
recommended battery types. Higher
usage decreases battery life.
• Recommended Battery Types: Duracell
DL123A, Energizer EL123AP, or
Panasonic CR123A.
• Compatible Receivers: EA102A-304
• Options: Magnet-RF-10 Assembly
(supplied in packages of ten)
1.5 Cables
1.5.1 C312: Transponder to ProxLink
Radio Module Cables
Description
Two cables - one cable provides power
from the Transponder to the ProxLink
Radio Module; the other cable provides
data transfer between the Transponder
and ProxLink Radio Module (non-
standard cable).
Specifications
• Power
- Length: 1.8 m (72 in.)
- Connectors: DC power plug at one
end (negative contact on
outside, positive contact in
center), flying leads on the
other end
• Data
- Length: 76 cm (30 in.)
- Connectors: Standard male DB9
connectors at each end, wired
special for data link. NOT a
standard cable.
1.5.2 Master to Slave
Note:
This cable is not supplied by Bosch
Security Systems.
Description
Null modem cable connecting the two
computers running the central console
software.
Specifications
• Maximum Length: 15 m (50 ft.)
• Connectors: To be compatible with
your PC’s requirements.
1.5.3 Computer to SE485 (not supplied)
Note:
This cable is not supplied by Bosch
Security Systems.
Description
This cable connects the SE485
Interface to the serial port of the
Security Escort central console.
Specifications
• Maximum length: 15 m (50 ft.)
• Connectors: The SE485 uses a DB25
pin male connector, the other end
depends on the computer serial port
connector. The wiring is a
straight-through serial cable.
1.5.4 Battery Cables
Description
C311: This kit is used to parallel
connect two small-lug-size batteries
to increase backup battery capacity.
1.6 Batteries
Bosch Security Systems recommends that
you supply your own 12 V lead-acid
batteries for system component back-up
time as needed for your installation.
However, some of the standard battery
sizes can be supported. See
Table 5
for the required amp hours of the
batteries for your installation.
Table 5: Battery Amp Hours
Amp hours (Ah) Required per
Number of Receivers
Number
of
Hours
8 16 32 64
4 2.3 3.5 5.7 10.2
8 4.6 7.0 11.4 20.4
12 7.0 10.3 17.0 30.6
24 14 20.6 34.0 ----
1.6.1 E28629B, Special 3 Ah
Description
Special size used especially for the
outdoor alert unit.
Comentarios a estos manuales