Bosch SE2005 Guia de preparacion descargar pdf (Pagina 32)

Security Escort | Installation and Setup Guide |3.0

Installation Instructions

EN | 32

Bosch Security Systems | 1/09 | 33831E

Figure 11: Back of AE100 Enclosure

1

2

1 - Use with single-gang electrical

boxes.

2 - Use with 9 cm (3.5 in.) square

electrical boxes.

Note:

The enclosure does not currently

support octagonal electrical boxes.

3.3.4 AE101 Outdoor Enclosure

This enclosure houses the receiver or

alert unit. It is suitable for outdoor

installation. See Section

1.7.4 AE101

Outdoor Enclosure for specifications.

Note:

Do not use this enclosure if you

intend to allow user feedback

through the sounder and LEDs of the

receiver.

Figure 12: Inside AE101 Enclosure

3.4 Mounting and Setting Up

Components

3.4.1 EA102 Receiver Installation

Mounting

Mount the electronic assembly to the

enclosure. Leave at least 10 cm (4

in.) of wire hanging out of the unit.

Do not leave extra wire inside the

enclosure as this could impact the

receiving antennas.

Set the Address

Every module on each multiplex bus of

the transponder must have its own

address. Set the address on the alert

unit using the address switch. See the

EA102 Installation Instructions.

Use only address numbers 0 through 7.

Do NOT use address numbers 8 and 9.

3.4.2 EA500 Transponder Installation

Mounting

Mount the electronic assembly to the

enclosure using the hardware kit

provided. See

Figure 13 and Figure 14

for mounting location.

Set the Address

Every transponder in the system must

have a unique address. Set the address

on the transponder using the DIP

switches in the upper-right corner.

Use the chart included in the

transponder’s Installation Guide for

the correct address settings.

Wiring

• Connect the bus wires.

• Connect the tamper switch wires.

• Connect the serial cable or SE485

wires (set the proper switch

position).

• Connect the output siren/strobe if

used.

• Connect the keyswitch if used.

• Connect 9 V output to ProxLink or

SE485 if used.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 53 54

Comentarios a estos manuales

Sin comentarios