Bosch SE2005 Guia de preparacion descargar pdf (Pagina 34)

Security Escort | Installation and Setup Guide |3.0

Installation Instructions

EN | 34

Bosch Security Systems | 1/09 | 33831E

Figure 14: EA500 Mounting to AE3 Enclosure

1 - AE3 Enclosure

2 - Circuit location

3 - Support post

4 - Battery location

5 - Circuit board

6 - Enclosure

7 - Support Post Assembly

Set the Address

Every transponder in the system must

have a unique address. Set the address

on the transponder using the DIP

switches in the upper-right corner.

Use the chart included in the

transponder installation guide for the

correct address settings.

Wiring

• Connect the bus wires.

• Connect the tamper switch wires.

• Connect the serial cable or SE485

wires (set the proper switch

position).

• Connect the output siren/strobe if

used.

• Connect the keyswitch if used.

• Connect 9 V output to ProxLink or

SE485 if used.

3.4.3 EA120 Alert Unit Installation

Mounting

The alert unit should be mounted

indoors; however, an outdoor enclosure

is available. The horn/strobe should

always be mounted outdoors.

Mount the circuit board to the

enclosure as indicated in

Figure 15

and

Figure 16.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

Sin comentarios

Bosch SE2005 Guia de preparacion Pagina 34